Keating Of Chicago Automobile Electronics Macro Switch Adjustment For Auto Top Side Head Actuator User Manual

S E R V I C E I N S T R U C T I O N S  
Part # 037797  
1-800-KEATING  
INSTRUCTIONS FOR MICRO SWITCH ADJUSTMENT  
FOR AUTO TOP SIDE HEAD ACTUATOR  
Tool needed: 2.5 mm Allen Wrench  
TOP SIDE HEAD UP  
TOP SIDE HEAD DOWN  
1. Remove the limits switch black  
plastic cover on the actuator.  
2. Turn on the power on unit and  
push the start button on the timer.  
The actuator will extend the stroke  
and lowers head. The motor must  
stop and the stroke should stop  
extending before it reaches its  
mechanical stop. This movement is  
controlled by the top micro switch.  
TOP SWITCH AND CAM  
BOTTOM SWITCH AND CAM  
3. If the motor fails to stop, manually  
depress the top micro switch actua-  
tor. This will disconnect power to the  
actuator motor. Loosen the set screw  
located on the top cam. Rotate the  
top cam clockwise until the switch is  
made (you should hear it click).  
(2) SWITCHES  
MOUNTED AS SHOWN  
TOP SWITCH SHOWN  
(TOP AND BOTTOM CAMS)  
SEE NOTE #3 − #8  
4. Tighten the set screw on the cam,  
use blue locktite.  
5. Turn on the power on unit and  
push the start button on the timer  
until it goes to the preset time. The  
actuator will retract the stroke and  
raise the head. The motor must stop  
and the stroke should stop retracting  
before it reaches its mechanical stop.  
This movement is controlled by  
MICRO SWITCH ACTUATORS  
FOR TOP AND BOTTOM  
SWITCHES SEE #3 − #8  
(SET SCREWS)  
SEE NOTES #3 & #4 FOR TOP MICRO  
SWITCH AND NOTES #6 & #7 FOR  
BOTTOM MICRO SWITCH  
bottom micro switch.  
SEE NOTE #1 − #9  
**NOTE THE TOP AND BOTTOM SWITCH ARE ASSEMBLED IN LINE.**  
6. If the motor fails to stop, manually depress the bottom micro switch actuator. This will disconnect power to the actuator  
motor. Loosen the set screw located on the bottom cam. Rotate the bottom cam counter clockwise, until the switch is made  
(you should hear it click).  
7. Tighten the set screw on the cam, use blue locktite.  
8. Test the top side head. Verify the adjustments did not change the length of the stroke, thus preventing correct function  
of the top side head. The top side cooking head must be able to reach the griddle plate. If it does not function properly  
complete steps #2 - #7.  
9. Reinstall the switches cover.  
part # 037797  
InstMSAdjTSHeadAct  
9/08  
 

Ingersoll Rand Marine Sanitation System 612058E User Manual
Insignia Flat Panel Television NS 32E859A11 User Manual
Intellinet Network Solutions Network Router INT 524315 UM 0808 1 User Manual
JBL Speaker HTPS 400 User Manual
JVC Automobile Parts RX F10S User Manual
JVC DVD Player SR HD2500US User Manual
Kenmore Washer 29522 User Manual
KitchenAid Dishwasher KUDB230B User Manual
Kompernass Electric Steamer SDG 800 A1 User Manual
Kompernass Hot Beverage Maker KH 1023 User Manual